Questions? Call Our team
of professionals for help @
Questions? Call Our team
of professionals for help @
Click for a larger image
| Price: | $119.00
|
FREE Shipping with orders over $199 (details) |
|
|
Out of Stock
|
|
Need a replacement housing? The MG-10MCB only fits in
Pentek Microguard HousingsThe MicroGuard membrane filters provide reliable bacteria and protozoan cyst reduction for safer and cleaner drinking water without incorporating chemicals into the media or adding chemicals to the filtered water. The MicroGuard carbon block membrane cartridge, MG-10MCB, is uniquely designed with integral carbon block and sediment pre-filtration for the reduction of chlorine taste and odor and for providing extended life of the internal membrane element. This cartridge has 2.5 times greater filtration surface area than some anti-microbial carbon blocks and operates at a higher flow rate with lower pressure drop. This makes the MG-10MCB ideal for Point-of-Use (POU) applications. The MicroGuard cartridges do not require USEPA registration and their effectiveness is not susceptible to common substances normally found in some waters, e.g., hydrogen sulfide (H2S), natural organic matter (NOM) and total dissolved solids (TDS).
| Model | Maximum Dimensions | Absolute µm Rating | Recommended Flow Rate | Initial ΔP @ Flow | Est. Capacity* |
|---|---|---|---|---|---|
| MG-10MCB | 10" × 2-7/8" | 0.15 µm | 1 GPM | 11 psid @ 1.0 GPM | 200-600 gal |
| MG-10T | 10" × 2-7/8" | 0.15 µm | 3 GPM | 13 psid @ 3.0 GPM | 600-1,800 gal |
* Capacities may vary depending on local water quality, type of pre-filtration and acceptable minimum flow rate.
Download Quick-Connect Instructions
Requires Adobe Acrobat Reader
Fitting grips before it seals. Ensure tube is pushed into the tube stop.
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the O-ring provides a permanent leak-proof seal.
Pull on the tube to check that it is secure. It is a good practice to test the system prior to leaving site and/or before use.
To disconnect, ensure the system is depressurized before removing the tube. Push in collet squarely against face of fitting. With the collet held in this position, the tube can be removed. The fitting can then be re-used.
Download Quick-Connect Instructions
Requires Adobe Acrobat Reader
Fitting grips before it seals. Ensure tube is pushed into the tube stop.
Push the tube into the fitting, to the tube stop. The collet (gripper) has stainless steel teeth which hold the tube firmly in position while the O-ring provides a permanent leak-proof seal.
Pull on the tube to check that it is secure. It is a good practice to test the system prior to leaving site and/or before use.
To disconnect, ensure the system is depressurized before removing the tube. Push in collet squarely against face of fitting. With the collet held in this position, the tube can be removed. The fitting can then be re-used.
John Guest is the originator of Quick-Connect Fitting Technology and the world leader. John Guest Fittings, Valves & Tubing are produced in the UK to exacting quality standards that are second to none!
